The short answer
Frame straightening has no list price, because the job ranges from a single pull on a slightly pushed rail to replacing frame sections and rebuilding the front end around them. Four things set the number: where the structure is bent, how far it moved, how many pull setups it takes to bring it back, and which structural parts have to be replaced instead of straightened. On top of that comes the body and paint work that the same crash caused, priced the way our auto body repair cost guide describes.
Almost every frame job we do is an insurance claim, because the kind of impact that moves a frame also damages bumpers, lights and panels. With a claim, your share is the deductible on your own policy, most often $500 or $1,000, or nothing at all when the other driver’s insurer pays. The free written estimate at our shop in Indian Trail takes about 10 minutes and itemizes the structural work separately from the cosmetic work, so you and the adjuster see the same numbers.
What moves the cost of frame repair
- Where the frame is bent. A front rail pushed back by a low-speed bumper hit is the simplest case. Damage at the strut towers, the firewall, the rocker panels or the rear rails sits closer to the passenger cell and takes more setups to correct.
- How far it moved. The frame is measured against the manufacturer’s dimensions before the pull. A few millimeters out on one point is one job; several points out in three directions is another.
- Pull versus replace. Mild bends are pulled back on the frame machine. A rail that is kinked, torn or stretched is replaced, either as a full section or by sectioning at the points the manufacturer allows, which adds parts, welding and corrosion protection to the bill.
- Unibody or ladder frame. Most cars and crossovers are unibody, so the frame and the body are one welded structure and the panels around the damage come into the job. Many trucks and some large SUVs sit on a separate ladder frame that is measured and straightened on its own.
- What else the impact bent. Control arms, a subframe, a steering rack or a radiator support often move together with the frame. They are listed on the estimate as their own parts and labor, and the job closes with a suspension and alignment check.
- The cosmetic repair on top. Bumper covers, fenders, hood and lights, plus paint blended into the neighboring panels, are priced the same way as any body repair: one painted panel runs about $300-500 as a general guide.
How the job runs at our shop
The frame or unibody is measured against the factory dimensions first, so the estimate shows the adjuster exactly which points are out and by how much. The car goes on the frame machine, the structure is pulled back in stages and re-measured until it is within specification, and sections that cannot be pulled are replaced following the manufacturer’s procedures. After the structure is right, the suspension geometry and alignment are checked, and only then do the outer panels, paint and lights go back on. The full process is on our frame straightening service page. Parts and labor carry our lifetime limited warranty.
Insurance, deductibles and the total-loss line
Frame work goes on the same claim as the rest of the collision repair. North Carolina law (G.S. 58-3-180) lets you choose the repair shop, so you bring the car to us, we send the written estimate to the adjuster, and once the claim is approved the structural work starts. If teardown shows damage the first estimate could not see, it goes to the insurer as a supplement before we fix it. We work directly with all insurers, most often Farm Bureau, Progressive, State Farm, National General and Allstate. How the whole claim works, step by step, is on our insurance claim repair page.
The insurer also compares the repair cost with what the car was worth before the crash. In North Carolina a car is treated as a total loss when the repair cost reaches about 75% of that pre-accident value, and the title is then branded. Frame work on a newer car usually stays well under that line; on an older car with low market value, a frame repair plus the cosmetic work can cross it. The itemized estimate shows you where your car stands before the insurer decides.
After a frame repair the car carries that history in its records, which can lower its resale value. In North Carolina you can claim that loss, called diminished value, from the at-fault driver’s liability insurer as a separate claim, usually with an independent appraisal. We give you the itemized repair invoice and measurement records you need for it.
Signs the frame moved, and what to do first
A car that drives straight after a crash can still be out of dimension, and a car with a bent frame often gives itself away: it pulls to one side, a wheel sits at a visible angle, the steering wheel is off center, the gaps around the hood or doors are uneven, or a door no longer closes without force. If you see any of those, have the car towed instead of driving it; towing is free for vehicles we repair. If everything works and the damage looks cosmetic, drive in to 109 Sherin Ln, Indian Trail during business hours, or send photos through the form below or call (704) 618-8755 for a preliminary number. The measurement, not the look of the car, decides whether frame work is needed.

